|
Drive nails FROM THE POINT out of :
|
Drive nails FROM THE HEAD:
|
Use the SAME denailer for the HEADS & THE POINTS of different nails.... |
|
flooring with nails,cleats, or staples
trim - wood, particle board & composites
|
- to countersink nails 1/8" (3 mm) or 3/8" (9.5 mm) deep to prepare for refinishing
- to set raised nails in decks, framing, & subfloors
|
|
- From the selections below note the tool needed for each range of nails you have.
- Determine the most common or most urgent size to remove.
- Click the tool for that range of nails.
- For the other ranges of nails, determine if you will need additional tools or if having additional driver/nose sets* on hand will work better. Select those pieces after putting the first tool in your cart. In addition to buying tools, you can buy up to 3 additional driver/nose sets and 1 set of recommended repair parts for each tool without paying for additional shipping.
|
* The only differences between the V20 denailer models is the diameter of the driver and its matched nose. We call that pair a "driver/nose set". They are designated by the letters DN, as in DN40 when sold separately from a tool. The number attached to V20 indicates the driver/nose set in the body; for instance V20-40 indicates a DN40 driver/nose set is in the body. Each driver/nose set can be removed from a tool body and replaced with one of the same or a different size in 3 to 5 minutes (see silent video). |
|
|
FIND YOUR FASTENER BELOW, THEN SELECT THE TOOL BELOW IT:
- Where all nails are 16d box nails or smaller (0.135", 9/64" or 3.76 mm in diameter). These nails will be less than 3 1/2" (90 mm) long.
- including flooring nails and cleats
- For flooring staples with a 3/16" wide crown (0.1875" or 4.8 mm)
- All nails are between sizes 16d box to 30d common (0.135"-0.207", 9/64"-13/64", or 3.75-5.26 mm diameter). These nails will be approximately 3 1/2-4 1/2" (90 - 115 mm) long.
- OR a very wide range of nail sizes between 6d box to 30d common (0.099"-0.207, 3/32"-13/64", or 2.51-5.26 mm diameter)
- For flooring staples with 7/16" (0.4375" or 11.1 mm) wide crown
|
FIND THE RANGE OF HEAD DIAMETER THAT FITS, THEN SELECT THE TOOL BELOW IT.
- heads < 5/16" diameter (0.312" or 7.92 mm)
- heads >= 5/16" diameter (0.312" or 7.92 mm)
|
FIND YOUR COMBINATION BELOW:
- For a very wide range of nail sizes between 6d box to 30d common (0.099"-0.207, 3/32"-13/64", or 2.51-5.26 mm diameter) AND occasionally drive heads <= 1/4" diameter (0.250" or 6.35 mm)
- all nails are 16d box nails or smaller (0.148", 9/64" or 3.76 mm in diameter) AND occasionally drive or set finish nails.
|
|
Still have questions?
Call 303-554-8557or email admin@reconnx.com
|
|
